
From farmsteads to suburbs since 1957
Spray Foam Insulation in Maplewood, MN
Maplewood's homes mostly date from the suburban decades. Their weak spots are predictable, and fixable.
- Free on-site estimates
- Written quote with material, depth and R-value for each area
- Air sealing done before any insulation covers it
Suburban Houses With Familiar Leaks
Spray foam insulation in Maplewood usually means working on houses from the second half of the 20th century. Point2Homes, using 2019-2023 census survey data, puts Maplewood's median construction year at 1979, with only 6.4% of homes built before 1940. The city incorporated in 1957 with about 14,200 people, after 3M opened its central research lab in the area, and had grown to 42,088 by the 2020 census.
Ramblers, split-levels and split-entries
Those decades produced a lot of ramblers, split-levels and split-entry homes. Their common trouble spots: rim joists that were left bare or covered with batts, a split-level's lower level that sits half in the ground and stays cold, rooms over the garage with little under the floor, and attics that were insulated to the standards of the day and then compressed by years of storage and service work.
What we usually recommend
Closed-cell foam on the rim joist is often the first step, since that band is easy to reach in an unfinished basement and leaks a lot. For the attic, we seal around light fixtures, bath fans and top plates, then add blown-in insulation toward the R-49 that Minnesota's Zone 6 code summary lists for ceilings. Bonus rooms over a garage get foam in the floor framing to block both cold and exhaust fumes.
Long and narrow city
Maplewood stretches about 10 miles north to south with a long southern leg, so we cover everything from the neighborhoods near Highway 36 and Maplewood Mall down to the southern stretch near the I-494 corridor.
Ranch attics and low eaves
Many ramblers in Maplewood have low-slope roofs, which leave only a few inches of space where the roof meets the outside wall. That tight corner is where insulation gets thin and frost forms first. We install rafter baffles to keep the soffit vents clear, then pack insulation as far toward the eave as the space allows, sometimes using a few inches of foam at the top plate where loose fill cannot reach full depth.
Finished lower levels
When a split-level's family room is already finished, we look for access along the rim from the unfinished side, through soffits or through small ceiling cuts. If there is no reasonable access, we tell you so and focus on the attic instead.
A note on 3M-era growth
With much of the city built in a 30-year span after incorporation, neighbors often have nearly identical houses. If yours works well after an upgrade, that is a fair preview for the street.
Call (651) 661-2833 to schedule a visit. Get a free estimate
What to Know in Maplewood
- Housing age. Median construction year 1979; 6.4% of homes built before 1940 and 13.5% added from 2000 to 2009 (ACS 2019-2023 via Point2Homes).
- Growth. Maplewood incorporated in 1957 with about 14,200 residents and counted 42,088 people and 16,569 housing units in the 2020 census (Wikipedia).
- City shape. The city runs 5.9 miles east to west and 10 miles north to south, including a 7.5-mile southern leg (Wikipedia).
- Code zone. Ramsey County is in Climate Zone 6 under Minnesota's energy code, with R-49 listed for ceilings (efficientwindows.org summary).

Maplewood Questions
My split-level's lower level is always cold. Can foam help?
Often. The rim joist and the above-grade part of the lower walls are the usual culprits. Closed-cell foam on the rim and, if the walls are open, on the concrete makes a noticeable difference.
Is my 1970s attic insulation enough?
Probably not by today's targets. Many attics from that era hold far less than R-49 once settled. We measure it and tell you how much to add after sealing.
Do you work in south Maplewood too?
Yes, the whole city, including the southern leg along the St. Paul border.
How long does a rim joist job take in a Maplewood rambler?
Most take a single day, including prep, spraying and cleanup, with re-entry timed to the foam maker's instructions.
Free Estimates in Maplewood, MN
Free on-site estimates across Maplewood.
Spray Foam Insulation Near Maplewood
- Spray Foam Insulation in St. Paul, MN
- Spray Foam Insulation in Roseville, MN
- Spray Foam Insulation in West St. Paul, MN
- Spray Foam Insulation in South St. Paul, MN
- Spray Foam Insulation in Inver Grove Heights, MN
- Spray Foam Insulation in Woodbury, MN
- Spray Foam Insulation in Oakdale, MN
- Spray Foam Insulation in North St. Paul, MN
- Spray Foam Insulation in White Bear Lake, MN
- Spray Foam Insulation in Shoreview, MN
- Spray Foam Insulation in Mendota Heights, MN
- Spray Foam Insulation in Eagan, MN
- Spray Foam Insulation in Cottage Grove, MN
- Spray Foam Insulation in Stillwater, MN
- Spray Foam Insulation in Vadnais Heights, MN
- Spray Foam Insulation in New Brighton, MN
- Spray Foam Insulation in Falcon Heights, MN
- Spray Foam Insulation in Little Canada, MN
- Spray Foam Insulation in Lake Elmo, MN
- Spray Foam Insulation in Mahtomedi, MN
- Spray Foam Insulation in Arden Hills, MN